Heidenhain tnc 155 iso9/22/2023 ![]() ![]() While the program was uploaded it ignored certain lines of code by placing a " " in front of the lines of code it does not like. I have tried a new program that cuts a 2D contour on a block of stock 100x100x10 stock.įirst i have shown the original program that was generated by fusion 360. This e-mail is subject to the following disclaimer available at N300 %HOLE G71 // All programs should end with N999 %HOLE G71 (2D POCKET1) //does not like this comment how do i disable all comments HeidenHain TNC 124 iso 50 / 1600 Rpm - incl. N25 G94 //does not like this line needs to be deleted Could you tell me how i would go about making changes in the cps file. the program works below with the following 3 changes as seen in the comments. What i am doing is 25.5 mm radius pocket of 10mm deep in the centre of the piece. I am having good progress with programming in iso (I tried the heindenhain and froze the machine ). ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |